smartctl --all /dev/sda (Prints all SMART information)
smartctl 7.3 2022-02-28 r5338 [x86_64-linux-5.19.0-15-generic] (local build)
Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Momentus 7200.2
Device Model: ST980813ASG
Serial Number: ########
Firmware Version: 3.ADD
User Capacity: 80,026,361,856 bytes [80.0 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database 7.3/5319
ATA Version is: ATA/ATAPI-7 (minor revision not indicated)
Local Time is: Wed Jan 11 17:43:23 2023 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: FAILED!
Drive failure expected in less than 24 hours. SAVE ALL DATA.
See vendor-specific Attribute list for failed Attributes.
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 119) The previous self-test completed having
the read element of the test failed.
Total time to complete Offline
data collection: ( 426) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 84) minutes.
SCT capabilities: (0x0035) SCT Status supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 100 253 006 Pre-fail Always - 0
3 Spin_Up_Time 0x0003 099 099 085 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 099 099 020 Old_age Always - 1480
5 Reallocated_Sector_Ct 0x0033 001 001 036 Pre-fail Always FAILING_NOW 31952
7 Seek_Error_Rate 0x000f 081 060 030 Pre-fail Always - 8853334264
9 Power_On_Hours 0x0032 081 081 000 Old_age Always - 17405
10 Spin_Retry_Count 0x0013 100 100 034 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 098 098 020 Old_age Always - 2079
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 5259
189 High_Fly_Writes 0x003a 098 098 000 Old_age Always - 2
190 Airflow_Temperature_Cel 0x0022 060 031 045 Old_age Always In_the_past 40 (Min/Max 24/43)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 10
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 1844
193 Load_Cycle_Count 0x0022 001 001 000 Old_age Always - 234936
194 Temperature_Celsius 0x001a 040 069 000 Old_age Always - 40 (0 12 0 0 0)
195 Hardware_ECC_Recovered 0x0012 073 061 000 Old_age Always - 137350076
197 Current_Pending_Sector 0x0010 100 097 000 Old_age Offline - 11
198 Offline_Uncorrectable 0x003e 100 097 000 Old_age Always - 11
199 UDMA_CRC_Error_Count 0x0000 200 200 000 Old_age Offline - 1
200 Multi_Zone_Error_Rate 0x0032 100 253 000 Old_age Always - 0
202 Data_Address_Mark_Errs 0x0000 100 253 000 Old_age Offline - 0
240 Head_Flying_Hours 0x0000 000 000 000 Old_age Offline - 17217 (111 247 0)
241 Total_LBAs_Written 0x0000 000 000 000 Old_age Offline - 11734329995
242 Total_LBAs_Read 0x0000 000 000 000 Old_age Offline - 170874401
254 Free_Fall_Sensor 0x0000 001 001 000 Old_age Offline - 513
SMART Error Log Version: 1
ATA Error Count: 6887 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 6887 occurred at disk power-on lifetime: 17395 hours (724 days + 19 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 f5 d0 4f e0 Error: UNC at LBA = 0x004fd0f5 = 5230837
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 01 f5 d0 4f e0 00 00:43:10.020 READ VERIFY SECTOR(S) EXT
42 00 01 f4 d0 4f e0 00 00:43:10.005 READ VERIFY SECTOR(S) EXT
42 00 02 f4 d0 4f e0 00 00:43:09.596 READ VERIFY SECTOR(S) EXT
42 00 04 f4 d0 4f e0 00 00:43:09.194 READ VERIFY SECTOR(S) EXT
42 00 04 f0 d0 4f e0 00 00:43:09.179 READ VERIFY SECTOR(S) EXT
Error 6886 occurred at disk power-on lifetime: 17395 hours (724 days + 19 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 01 f4 d0 4f e0 Error: UNC at LBA = 0x004fd0f4 = 5230836
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 01 f4 d0 4f e0 00 00:43:10.020 READ VERIFY SECTOR(S) EXT
42 00 02 f4 d0 4f e0 00 00:43:10.005 READ VERIFY SECTOR(S) EXT
42 00 04 f4 d0 4f e0 00 00:43:09.596 READ VERIFY SECTOR(S) EXT
42 00 04 f0 d0 4f e0 00 00:43:09.194 READ VERIFY SECTOR(S) EXT
42 00 08 f0 d0 4f e0 00 00:43:09.179 READ VERIFY SECTOR(S) EXT
Error 6885 occurred at disk power-on lifetime: 17395 hours (724 days + 19 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 02 f4 d0 4f e0 Error: UNC at LBA = 0x004fd0f4 = 5230836
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 02 f4 d0 4f e0 00 00:43:10.020 READ VERIFY SECTOR(S) EXT
42 00 04 f4 d0 4f e0 00 00:43:10.005 READ VERIFY SECTOR(S) EXT
42 00 04 f0 d0 4f e0 00 00:43:09.596 READ VERIFY SECTOR(S) EXT
42 00 08 f0 d0 4f e0 00 00:43:09.194 READ VERIFY SECTOR(S) EXT
42 00 10 f0 d0 4f e0 00 00:43:09.179 READ VERIFY SECTOR(S) EXT
Error 6884 occurred at disk power-on lifetime: 17395 hours (724 days + 19 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 04 f4 d0 4f e0 Error: UNC at LBA = 0x004fd0f4 = 5230836
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 04 f4 d0 4f e0 00 00:43:10.020 READ VERIFY SECTOR(S) EXT
42 00 04 f0 d0 4f e0 00 00:43:10.005 READ VERIFY SECTOR(S) EXT
42 00 08 f0 d0 4f e0 00 00:43:09.596 READ VERIFY SECTOR(S) EXT
42 00 10 f0 d0 4f e0 00 00:43:09.194 READ VERIFY SECTOR(S) EXT
42 00 10 e0 d0 4f e0 00 00:43:09.179 READ VERIFY SECTOR(S) EXT
Error 6883 occurred at disk power-on lifetime: 17395 hours (724 days + 19 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 04 f4 d0 4f e0 Error: UNC at LBA = 0x004fd0f4 = 5230836
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
42 00 08 f0 d0 4f e0 00 00:43:07.134 READ VERIFY SECTOR(S) EXT
42 00 10 f0 d0 4f e0 00 00:43:07.129 READ VERIFY SECTOR(S) EXT
42 00 10 e0 d0 4f e0 00 00:43:09.596 READ VERIFY SECTOR(S) EXT
42 00 20 e0 d0 4f e0 00 00:43:09.194 READ VERIFY SECTOR(S) EXT
42 00 20 c0 d0 4f e0 00 00:43:09.179 READ VERIFY SECTOR(S) EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed: read failure 70% 11805 116337475
# 2 Short offline Interrupted (host reset) 10% 330 -
# 3 Short offline Completed without error 00% 1 -
# 4 Short offline Completed without error 00% 0 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
No comments:
Post a Comment